Home > Support > FAQPrint

FAQs Frequently Asked Questions

FAQ is provided to troubleshoot your problem while using TOTOLINK products. You can enter keywords to find solution to your issue. Search by entering keywords and selecting a product.

A3 WISP Settings

  • 2017-11-30

    This document applies to A3

    Diagram 

     

     

     

     

    Preparation

     

    Before configuration, make sure that both A Router and B Router are powered on.

    Connect your computer to the same network of router A and B.

    move the B router closer to the A router to find the B routing signals better for fast WDS.

    A Router and B Router should be set to the same channel.

    Set both Router A and B to the same band 2.4G or 5G.

    Choose the same models for A-router and B-router. If not, WDS function may not be implemented.

     

    Set up steps

    STEP-1 A-Router Wireless Setup

     enter the settings page of the A Router, then follow the steps illustrated.

          In the navigation bar, select Basic Setup->Wireless Setup-> Select 2.4GHz Basic network

          Setting Network SSID, channel, Auth, password

          Click the Apply button

          Repeat the steps 3 through 5 to complete the 5GHz Wi-Fi configuration


    STEP-2

    B-Router Wireless Setup

    enter the settings page of the B Router, then follow the steps illustrated.

         In the navigation bar, select Basic Setup->Wireless Setup-> Select 2.4GHz Basic network

         Setting Network SSID, channel, Auth, password

         Click the Apply button

         Repeat the steps 3 through 5 to complete the 5GHz Wi-Fi configuration


    STEP-3

    Set up WDS on A-router

       Enter the setup page on router A, then follow the steps below.

        In the navigation bar, select Advanced Setup->Wireless->Wireless Multibridge.

        For Wireless Multibrige, select 2.4GHz. If you want to use 5GHz for WDS, choose 5GHz.

        In Mode list, select WDS.

      Click the Ap Scan button.

     

     

    In 2.4G Wireless Network list, select B-Router for WDS.  Click the Apply button.


     

     

    STEP-4

    B-router WDS setting

    enter the settings page of the router B, then follow the steps illustrated.

         In the navigation bar, select Advanced Setup->Wireless->Wireless Multibridge

         For Wireless Multibrige, select 2.4GHz.( You must choose the same channel as Router A.)

         In Mode list, select WDS.

        Click the Ap Scan button 


     In 2.4G Wireless Network list, select A-Router for WDS  click the Apply button.

     

    STEP-5

    Turn off the B-routed DHCP server

    In order to avoid A router and B router DHCP server conflict, follow the steps below to disable the B Router DHCP function.

     

     

    STEP-6

    Restart B router

    Follow the following steps to restart Router B. Or you can directly disconnect the router from its electrical outlet. Once Router B is rebooted, Routers A and B are connected successfully via WDS.


    STEP-7

    B Router position display

    Move the Router B to a different location for a best Wi-Fi access.


     

Newsletter   l   Change Region   l   Contact us
COPYRIGHT 2014 TOTOLINK ., ALL RIGHT RESERVED